Advertenties
Beschikbare talen
Beschikbare talen
Fitting the side handle
CAUTION
Risk of injury Loss of control over the product.
▶
Check that the side handle is fitted correctly and tightened securely. Check that the clamping band
is engaged in the groove in the product.
1.Release the side handle clamping band by turning the handle grip.
2.Slide the side handle clamping band over the tool holder from the front and into the recess provided.
3.Set the side handle to the desired position.
4.Tighten the side handle clamping band by turning the handle grip.
Fitting the depth gauge (optional)
1.Release the side handle clamping band by turning the handle grip.
2.Slide the depth gauge from the front into the 2 guide holes provided.
3.Tighten the side handle clamping band by turning the handle grip.
Control switch lock
When chiseling, the control switch can be locked in the "on" position.
▶
Press the control switch lock.
4
Inserting the tool
The use of unsuitable grease can cause damage to the product. Use only genuine Hilti grease.
1.Lightly grease the connection end of the accessory tool.
▶
Use only genuine Hilti grease. Using the wrong grease can result in damage to the product.
2.Push the accessory tool into the chuck as far as it will go (until it engages).
3.After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶
The product is ready for use.
Removing the accessory tool
▶
Pull the tool lock back as far as it will go and remove the accessory tool.
Use only genuine Hilti grease. The use of unsuitable grease can cause damage to the product.
Setting the power level
Power can be set only when the tool is switched on and ready for use.
To set the tool to half power, press the "half power" button. The power indicator lights up to
indicate reduced power. Press the "half power" button again to switch to full power. The power
indicator goes out.
Switching the product off and then on again resets it to full power.
▶
Set the power level.
Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool
without an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶
Irrespective of whether mains power or generator power is used, always make sure that an
earth/ground conductor and ground fault circuit interrupter are present in the power supply and
that these are correctly connected.
▶
Do not use the product unless these safety measures are in place and fully operational.
*2244431*
2
3
5
2244431
19
Advertenties
