Advertenties
Beschikbare talen
Beschikbare talen
The battery can be damaged by sharp objects such as a nail or
screwdriver or by external force. An internal short circuit may occur and
the battery may burn, smoke, explode or overheat.
Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorised service providers.
Protect the battery from heat, including prolonged exposure to
sunlight, fire, dirt, water and moisture.
There is a risk of explosion and short circuit.
Operate and store the battery only at an ambient temperature between
– 20 °C and + 50 °C. Do not leave the battery in your car in the summer, for
example. At temperatures < 0 °C, performance may be reduced depending on
the device.
Charge the battery only at an ambient temperature between 0 °C and
+ 35 °C. Charging outside of the temperature range can damage the battery
and increase the risk of fire.
After use, allow the battery to cool down for at least 30 minutes before
charging or storing it.
1.3.3. Additional electrical safety warnings
DANGER!
Risk of cardiac arrest
This product generates an electromagnetic field while it operates.
This electromagnetic field may affect the functionality of active or
passive medical implants (e.g. pacemakers), which may result in
serious injury or death.
Consult your doctor and the manufacturer of your implant
before using this product.
Remove the battery when you are not using the product.
Do not expose the battery and battery charger to rain, water or wet conditions.
Avoid excessive use of the product to avoid overheating the motor and battery.
Remove the battery immediately in case of an emergency.
1.3.4. Additional personal safety warnings
DANGER!
Risk of suffocation
Small parts can easily be swallowed. There is also a risk that the
polybag can suffocate toddlers.
Keep small children away when you assemble the product.
Use only original GARDENA accessories. Unsuitable brushes can lead to an
increased risk of brushes developing faults or of flying objects.
Use the product only when the safety guard is fitted.
Do not touch moving parts.
Do not use the product to the point of fatigue or exhaustion.
Always perform a short test run before use to check for possible effects on the
surfaces of the paving stones or panels.
2. ASSEMBLY
DANGER!
Risk of injury
If the product starts accidentally, people can be injured by the
weed brush.
Remove the battery before assembling the product.
Do not touch moving parts.
2.1. Scope of supply
Cordless weed brush
Steel wire brush
Battery charger
Battery (2 Ah)
Operator's manual
The weed brush is supplied pre-assembled.
2.2. Replacing the brush [Fig. A1]
The GARDENA spare parts are available from your GARDENA dealer
or from GARDENA Service.
Two GARDENA Weed Brushes are available:
• GARDENA steel wire weed brush art. 14821: For heavy soiling in
joints on resistant surfaces.
• GARDENA nylon weed brush Art. 14822: For gentle cleaning on
scratch-prone surfaces.
Only use an original GARDENA Weed Brush.
12
GAR_14820-20.960.02_2023-11-28.indd 12
GAR_14820-20.960.02_2023-11-28.indd 12
Art. 14820-20
Art. 14820-55
x
x
x
x
x
-
x
-
x
x
Wear protective gloves to avoid being injured by the weed brush.
1. Loosen the Allen screw
using an Allen key (width 4 mm) by turning
1
clockwise (left-hand thread).
2. Remove the Allen screw
together with the washer
1
brush holder
.
4
3. Pull the weed brush
sideways from the weed brush holder
3
pull the weed brush
downwards out of the safety guard
3
do so, make sure that the weed brush holder
4. Slide the desired new weed brush
neath
and place the weed brush
5
5. Place the washer
onto the weed brush holder
2
6. Insert the Allen screw
into the weed brush holder
1
7. Tightly screw the Allen screw
1
an Allen key (width 4 mm) by turning anticlockwise (left-hand
thread).
3. OPERATION
DANGER!
Risk of injury
If the product starts unintentionally, people can be injured by the
weed brush.
Remove the battery before adjusting the product.
3.1. Charging the battery [Fig. O1/O2/O3]
CAUTION!
Damage to property
If the voltage of the power source does not match the specifications on
the battery charger rating plate, the battery charger may be damaged.
Note the mains voltage.
DANGER!
Risk of injury
Inserting the battery may cause you to trap your fingers.
Mind your fingers.
The smart charging process automatically detects the battery's state of
charge and charges it using the optimum charging current depending on
the battery temperature and battery voltage. This protects the battery and
keeps it fully charged when stored in the battery charger.
1. Press the release button
and remove the battery
A
battery holder
.
D
2. Connect the battery charger
to a power outlet.
C
3. Slide the battery charger
onto the battery
C
When the battery charge indicator
green, the battery is charging.
When the battery charge indicator
continuously green, the battery is fully charged (charging time, see
7. TECHNICAL DATA).
4. Check the state of charge at regular intervals while charging.
5. When the battery
is fully charged, the battery can be
B
from the
battery charger.
C
3.2. What the indicator elements mean
3.2.1 Battery charge indicator on the battery charger [Fig. O3]
Flashing battery
The charge cycle is indicated by the battery charge indicator
flashing
.
charge indica-
Lc
tor
Note: The charge cycle can be carried out only if the temper-
Lc
ature of the battery is within the permissible charging temper-
ature range, see 7. TECHNICAL DATA.
Battery charge
A solid light on the battery charge indicator
the battery is fully charged or that the temperature of the bat-
indicator shows
tery is outside of the permissible charging temperature range
solid light
Lc
and it cannot therefore be charged. As soon as the permissi-
ble temperature range is reached, the battery is charged.
If the battery is not inserted, a solid light on the battery
charge indicator signals
the power outlet and that the battery charger is ready for use.
from the weed
2
and
4
. As you
5
remains on the axis.
4
into the safety guard from under-
3
onto the weed brush holder
3
.
4
,
4
into the weed brush holder
using
4
from the
B
.
B
on the battery charger is flashing
Lc
on the battery charger glows
Lc
disconnected
B
signals that
Lc
that the mains plug is inserted into
Lc
28.11.23 13:43
28.11.23 13:43
.
4
Advertenties
