Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
power input and output
2
sensitivity adjustment knob
3
microphone
4
DMX input
5
DMX output
6
LED display
7
MENU button
8
UP button
9
DOWN button
6.
Installation
Safety
Before mounting the product, read and follow the safety recommendations indicated in the Safety
Instructions.
Orientation
Before deciding on a location, make sure there is easy access to the product for maintenance and
programming.
The VDPLDJBAR8 can be mounted in any position. Make sure adequate ventilation is provided
around the product.
The bracket adjustment knobs allow for directional adjustment when aiming the product to the
desired angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the
knobs.
Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket.
Connect the power cord to the mains. Disconnect after use.
Stand
Set up the stand to its desired position.
Slide the T-bar onto the stand and tighten all fasteners.
Rigging
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
The installation must always be secured with a secondary attachment such as a safety cable
(e.g. VDLSC7N or VDLSC8N). The secondary attachment shall be designed and mounted in such a
way that no part of the device can fall if the primary attachment fails.
Make sure that the safety cables can carry 10 times the weight of the device. Make sure that the
maximum height of drop is limited so that no injuries can occur. If the safety cables are long, wrap
them around the truss multiple times to reduce the height of drop to a safe level.
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
Make sure there is no flammable material within a 0.5 m radius of the device.
V. 01 – 25/11/2014
VDPLDJBAR8
10
ENTER button
11
LED interface
12
connection cable
13
footswitch interface
14
LED panel
15
adjustment knob
16
stand connector
17
ground interface
5
©Velleman nv
Advertenties
Inhoudsopgave
