Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Fixture
1. handle
2. fan
3. housing
4. mirror
5. effect switch
6. fuse holder
7. housing screw
b) Lamps
Always disconnect the main power and allow the fixture ample time to cool down before attempting to replace the
lamp. Remember that you have to replace the lamp with the same type of lamp.
1. Be sure to follow the right procedure when handling halogen lamps. Never touch the new lamp with your
bare fingers.
2. Tweak the screws located on the bottom of the unit.
3. Remove the lamp cover to expose the lamps.
4. Remove and replace the lamps.
5. Reassemble in reverse order.
Remark: Do not operate the device when the cover is open
c) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are you will need to replace the fuse as well.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse-holder above the power-supply.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
d) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The construction to which the device is attached should be able to support 10 times the weight of the device for
one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
VDL250GL_v2
3
VELLEMAN
Advertenties
Inhoudsopgave
