Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Flame e昀昀ect does not turn on
In some cases, the display an
error code followed by an X to
indicate which sump(s) regis-
tered the error .
For example, where there are
three 昀氀ame modules and the
middle one is a昀昀ected, the
display will 昀氀ash the error
code, followed by _X_ .
Flame Connect App-related
error
CD44
Extractor fan(s) error
CD45
Incorrect number of
modules detected .
CD51
Low water level in one
of the sumps .
The timing for 昀椀lling the
CD56
sump has been maxed
out .
CD57
Possible leak in the
unit .
Over昀氀ow has been de-
CD58
tected .
CD53
Fireplace settings are
out of sync with the
app .
30
See service manual .
See service manual .
Restart the unit by turning
the power o昀昀 from the power
switch or breaker for 10 sec-
onds before turning it back on .
Check plumbing connections .
If error persists, see service
manual .
Restart the unit by turning
the power o昀昀 from the power
switch or breaker for 10 sec-
onds before turning it back on .
Check water pressure and
plumbing connections .
If error persists, see service
manual .
Restart the unit by turning
the power o昀昀 from the power
switch or breaker for 10 sec-
onds before turning it back on .
Check water pressure and
plumbing connections .
If error persists, see service
manual .
Inspect the modules and care-
fully remove excess water .
See service manual .
Open the app on your mobile
device to synchronize settings .
Advertenties
Inhoudsopgave
