Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Priming the Unit
The unit will need to be primed with water prior to the 昀椀rst use and whenever the sumps are fully
emptied (such as after cleaning or maintenance) .
Once the unit is connected to water and electrical supply, prime the unit using the hidden touch
controls (Figure 12) by following these steps:
1. Ensure the water valve is open . (Figure 8)
2. Put the power switch in the "on" position .
3. While the unit is in standby mode, press and hold
by and the 昀氀ame intensity icon ( ) will illuminate .
4. Press and hold
priming . Once the 昀椀lling is complete, the display will show "FULL", the icon will disappear, and
4 beeps will follow . The unit will return in standby mode .
5. To start the unit press
Maintenance
Remote Control Battery Replacement
To replace the batteries:
1. Remove battery cover of the remote control using a Philips screwdriver .
2. Correctly install two 3 Volt (CR2032 or similar) battery in the battery holder with the + side facing
up .
3. Secure the battery cover using the previously removed screw .
Batteries must be recycled or disposed of properly . Check with your Local Authority or Retailer for
recycling advice in
Frequency band(s) this product operates in: 2.4GHz Maximum radio-frequency power transmitter in
the frequency band(s) this product operates in: 2.71dBm.
Cleaning
WARNING: Disconnect power and allow heater to cool before attempting any maintenance or
cleaning to reduce the risk of 昀椀re, electric shock or damage to persons .
CAUTION: The heater should not be operated with an accumulation of dust or dirt on or in the unit,
as this can cause a build-up of heat and eventual damage . For this reason the heater must be in-
spected regularly, depending upon conditions and at a minimum yearly intervals .
Fireplace Surface Cleaning
Use only a damp cloth to clean the glass and painted surfaces of the 昀椀replace . The inner side of the
glass may occasionally get cloudy and require cleaning . Do not use abrasive cleaners .
Component Cleaning
It is required that the top cover, sump, water bottle (if used), and transducers are cleaned with soap
and water on a regular basis, at a minimum once per month . More frequent cleaning may be re-
quired depending on water quality .
CAUTION: Do not put plastic components in the dishwasher .
The 昀椀lters can be removed and gently rinsed with water to clean and dried on a towel before rein-
stalling . Reinstall the 昀椀lter so that the coarse black side of the 昀椀lter is facing the back of the unit .
See Figure 14
for 3 seconds . "FILLING" will scroll across the display for the duration of the
once . The warm up sequence will start .
your area .
for 5 seconds . The unit will remain in stand-
27
Advertenties
Inhoudsopgave
