Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Additonal Functions to be Performed from the Remote Control
Timer
Heat Mode
Selection
Increase
Flame Inten-
sity
Decrease
Flame Inten-
sity
Increase
Volume
Decrease
Volume
Resetting the Temperature Cuto昀昀 Switch
Should the heater overheat, a manual limit cut-out will turn the unit o昀昀 and it will not come back on
without being reset . It can be reset by turning the unit o昀昀 from the main ON/OFF switch or at the
main disconnect panel and waiting 10 minutes before turning the unit back on .
Factory Reset
Performing a factory reset will restore all settings to default, disconnect the unit from the mobile app
if connected, and remove any primary and guest users . This can also help resolve issues connect-
ing to the Flame Connect App .
1. To reset all the settings to factory default:
2. Turn the power o昀昀 for 10 seconds at the main power switch .
3. Turn the power back on . The unit will start the warm-up sequence .Once the warm-up sequence
is complete, press and hold
performed on the hidden touch controls .
repeatedly to set the duration of the timer. The 昀椀replace goes
Press
into standby after the time has elapsed. The timer can be set from 30
minutes (display shows 0.5Hr) to 8 hours in intervals of 30 minutes.
To turn the timer o昀昀, press
While the timer is active, press the timer button to see the time remain-
ing.
repeatedly to cycle through the di昀昀erent heat modes:
Press
Normal: The heater automatically adjusts to achieve and maintain the
set temperature.
Eco: The heater will work at reduced power to save energy.
Heat Boost: The heat is on at maximum power for a preset amount of
time before reverting to normal heat mode. Select BST1 for 5 minutes,
BST2 for 10 minutes, or BST3 for 15 minutes.
Frost Protection: The heater maintains the ambient temperature at
7° C (45° F). To indicate this mode, overhead lights are blue and the
display indicates -FP- continually. The 昀氀ame e昀昀ect cannot be turned on
in this mode.
Fan: The fan runs without heat to circulate the in the room.
to increase the 昀氀ame intensity setting to MED (medium) or
Press
HIGH.
to decrease the 昀氀ame intensity setting to LOW or MED (medi-
Press
um).
Press
repeatedly (or press and hold) to decrease the volume level of
the crackling sound e昀昀ect.
Press
repeatedly (or press and hold) to increase the volume level of
the crackling sound e昀昀ect.
The volume of the crackling sound e昀昀ect can be set from OFF to level 6.
to brie昀氀y display the current volume setting.
Press
or
and
at the same time for 10 seconds . This action must be
after 8 and the display indicates OFF.
26
Advertenties
Inhoudsopgave
