Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7. Place the mixing tool 20/21/22 onto
the axle 23 from below.
Ensure that the small metal pins on the
axle 23 slot into the recesses in the mix-
ing tool 20/21/22.
8. Figure A: press the mixing tool 20/
21/22 upwards slightly and rotate it
anticlockwise until it stops.
Adding ingredients
• You can add ingredients into the mixing
bowl 16 while the drive arm 19 is lift-
ed up.
• During mixing, you can add ingredients
through the filling opening 10 in the
splash guard 18:
- Reduce the speed to 1 - 2.
- Open the flap of the filling open-
ing 10.
- Add the ingredients.
- Close the flap of the filling open-
ing 10 again.
Lowering the drive arm
DANGER of hand injuries by
crushing!
Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
12 GB
9. Press the unlock button 11 and move
the drive arm 19 all the way down. The
unlock button 11 pops out again.
The device is now fully assembled. On work-
ing with the device: see "Basic operation"
on page 15.
8. Using the blender
jug
r b o
T u
DANGER! Risk of injury from
cutting!
Please remember that the blades of the
blade assembly 7 are very sharp:
- Never touch the blades with your
bare hands in order to avoid cuts.
- When emptying the blender jug 5,
ensure not to touch the blades of the
blade assembly 7.
WARNING! Risk of material dam-
age!
Do not use the blender jug for process-
ing particularly hard foodstuffs, such as
frozen food, bones, nutmeg, cereals or
coffee beans.
NOTE: when you use the blender jug 5, the
axle 23 also turns. The mixing bowl 16 and
splash guard 18 should therefore also be
mounted, but not a mixing tool 20/21/22.
Using and removing the blade
assembly
The blender jug 5 must never be used with-
out the blade assembly 7, since the blade
assembly 7 seals the blender jug 5 on the
bottom.
Advertenties
Hoofdstukken
Inhoudsopgave
