Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
SWING (23)
EN
Activate / deactivate rotation
When this function is active, the vertical slats of the ventilation grille (3) automatically
swing from one side to the other.
COOL (24)
Activate / deactivate cooling and humidification
Please Note!
This function can only be used with a filled water tank (10).
When this function is active, the water is pumped from the water tank into the water tray
(17) and from there it runs out over the honeycomb filters (4) back into the water tank. In
the process, the honeycomb filters are moistened and thus cool the air flow. In addition,
the air is humidifi ed.
Once the water in the water tank has been used up, you will hear beeps
and the COOL control lamp flashes. The pump switches off automatically.
POWER (25)
Switch the device on / off
Remote Control
The buttons on the remote control
(Picture D) correspond to the functions of the
operating elements on the control panel (2). Only
the function of the COOL button is different.
Whereas the COOL fi eld (24) on the control panel
is intended both for activating and deactivating
the cooling and humidifi cation, this function can
only be activated using the COOL button on the
remote control. To deactivate the function and
accordingly switch to pure ventilation without
cooling, the WIND button on the remote control
must be pressed.
FILLING THE WATER TANK
Please Note!
•
Only ever fill the water tank with cold tap water. Do not use any other liquids.
•
Do not overfill the water tank (max. 10 l)! Electrical components could be damaged.
Increased risk of an electric shock.
10
1. Make sure that the device is not connected to the mains power.
2. Flip open the cover (1).
3. Carefully pour cold tap water into the water tray (17). When you do this, make sure
that the water tray does not overfl ow.
4. Flip the cover shut.
The water runs out of the water tray into the water tank (10) below the honeycomb filters
(4).
Alternative Filling
To fill the water tank, the device may
alternatively also be taken apart.
1. Release the two closure clasps
(11) of the water tank on the sides
of the device by levering them up
from below.
2. Reach into the recessed grips,
lift up the top part of the device
and detach it from the water
tank. Please note!Always place
the detached part down on a
moistureresistant surface.
D
3. Fill the water tank (Picture C).
4. Place the detached part of the device on the water tank. Make sure that the water
level indicator (6) is facing forwards.
5. Fix the water tank with the closure clasps on the housing (13).
INSERTING / CHANGING BATTERIES IN THE REMOTE
CONTROL
Before inserting the batteries, check whether the contacts in the remote control and on
the batteries are clean, and clean them if necessary.
1. Slide open the battery compartment cover in the direction of the arrow and take it off.
2. Take out used batteries if necessary and replace them with two new batteries (1.5 V;
AAA). Pay attention to the correct polarity (+ / –).
3. Place the battery compartment cover on the battery compartment and slide it counter
to the direction of the arrow to shut it.
Replace the batteries if the power of the remote control starts to wane.
For an even better cooling result, ice packs (not supplied with the device)
or ice cubes can optionally also be placed in the water tank.
EN
11
Advertenties
Inhoudsopgave
