Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
STARTING A WASH CYCLE
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
Ensure that they are clean and properly positioned. See the section Cleaning and Maintenance.
4. Check that there is rinse aid and salt.
5. Load the dishes.
Ensure that the spray arms can rotate freely.
6. Add the required amount of detergent into the dispenser according to the Washing Program chart.
7. Press
to switch on the dishwasher.
8. Repeatedly press
The corresponding programme indicator light will illuminate.
Delay Timer: The delay timer allows you to delay the start of a washing program from 1 hour up
to 24 hours.
Repeatedly press
e.g. 03 for a 3-hour delay.
Once the delay timer has been set, close the door to activate the function.
To cancel the delayed start, repeatedly press
9. If you want to perform a half load wash, press
illuminate.
When you have about or less than 6 place setting dishware to wash, you can choose this function
to save energy and water.
This function can only be used with Intensive, Universal, ECO, Glass and 90 min.
10. Close the door securely. The washing cycle will start.
11. After the program has ended, the diswasher will buzz and stop.
If the dishwasher is set for a delay start, the dishwasher wil not buzz.
On the display, "00" will flash for a few seconds and then "--" will be displayed.
After a period of time, the display will shut off and the dishwasher will turn off.
12. Wait for 15 minutes before you open the dishwasher door in order to avoid burns.
13. Unload the dishes.
WARNING!
The washing cycle will not start if the dishwasher door is left open or not properly closed.
Do not open the door when the dishwasher is working since hot water may be ejected, which could
cause scalding.
Adding extra dish
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow
the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. The cycle will start from the point at which it was interrupted.
to select the desired washing program.
until the desired delayed start time is shown on the display,
until the display shows "00".
and the corresponding indicator light will
EN-21
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
