Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
BEFORE INSTALLING YOUR DISHWASHER
Before connecting your dishwasher to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. The appliance must be grounded. The
manufacturer is not responsible for damages that may occur as a result of usage without grounding.
WARNING: Disconnect electrical power before installing your dishwasher.
INSTALLATION INSTRUCTIONS
Your dishwasher can be installed in various locations in your kitchen as long as there is space and
accessibility to connect your dishwasher to the water/drainage and electrical supply.
Do not connect an extension lead to the appliance to avoid potential safety hazards.
Applying the Condensation Strip
The condensation strip must be fitted to the underside of the worktop to protect it against the ingress of
moisture.
1. Ensure that the underneath of the worktop is clean.
2. Separate the backing paper away from the strip.
3. Stick the condensation strip to the underneath of the worktop.
Cold Water Connection
The installation of the hose should be done by professionals.
Connect the supplied water supply hose to a threaded 3/4" connector and
make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear. This precaution is
needed to avoid the risk of the water inlet to be blocked and damage the
appliance.
Connection of the Drain Hose
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink,
making sure to avoid bending or crimping it. The height of drain pipe must be less than 1000mm. The
free end of the hose must not be immersed in water to avoid the back flow of it.
Please securely fix the drain hose in either position A or position B.
The installation of the hose should be done by professionals.
EN-7
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
