Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
b) Setting the anti-skating compensation
• Set the anti-skating control (17) to the needle resting weight value specified for that pick-up system. For
a needle pressure of, e.g., 20 mN you have to set the anti-skating control (17) to "2".
• The recommended setting for the supplied system is "3-4".
c) Setting the overhang
The overhang is the distance between the pick-up needle and the turntable axis (4).
This overhang has already been factory set. If you should come to changing to a different pick-up system,
you can set the overhang as follows:
• The overhang of the pick-up arm (11) should be set to 16 mm for best playback.
• To achieve this loosen both of the screws on the pick-up system (8) headshell and slide the pick-up
system into the correct position.
• Always make sure that while you are making these settings, the pick-up system (8) remains attached to
the system carrier in a parallel position.
• Tighten both screws again.
16mm
37
Advertenties
Hoofdstukken
Inhoudsopgave
