Download Inhoudsopgave Inhoud Print deze pagina

ECM Manufacture Technika IV Handleiding pagina 33

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Problem
Little or no crema on top of the
coffee
Sparse coffee dispensing, only drop
by drop
Weak "body"
Foam instead of crema
The machine is switched on, but the
machine does not work.
The machine does not stop working
when there's no water in tank and
takes in air.
Portafilter/ brew group is dripping.
If the machine will not be used for a long period of time, it is recommended to
.. clean the brew group (see instructions in chapter 7.2). Afterwards, please do not clamp the portafilter back into
the group.
.. empty the boiler. Switch the machine off (power switch in position "0") and open the hot water dispenser. Due to
the boiler pressure, the boiler water is now discharged by the hot water dispenser. Close the hot water handle
(MECHANIKA / TECHNIKA) or the hot water lever valve (MECHANIKA PROFI / TECHNIKA PROFI) again after
emptying the boiler. To restart the machine, see chapter "First use".
How to froth milk like a "barista"
If possible, use cold and fresh milk with a fat content of approx. 1.5 % or 3 %. Even homogenized milk is
suitable - if you prefer.
Use a frothing container (made of metal) with a minimum volume of 0.5 litres. The size of the container should
not be too wide. A narrow and high container is perfect.
Open the steam valve for approx. 5 seconds to release the condensation water and to create dry steam.
Instruction manual MECHANIKA · TECHNIKA
Possible Cause
The amount of ground coffee is not
enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground coffee.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is not
enough.
The shower screen is dirty.
The beans are improper.
The setting of the coffee grinder is
not suited for the coffee beans in
use.
The orange signal lamp is switched
off, there is not enough water in the
water tank.
Water was refilled, the orange
control lamp is switched off.
The water tank is not fixed properly.
Machine in use with direct water
connection, but switch in
position "0" (=position water tank).
Machine does not take in water.
Machine in use with water tank, but
switch in position "1" (= position
direct water connection).
Portafilter is not fixed properly.
Group gasket is broken.
32
Troubleshooting
Use the right coffee amount:
Approx. 7 g of coffee for each cup.
Clean the brew group.
Use a coarser grind.
Tamp ground coffee only slightly.
Increase the brewing-pressure.
Use approx. 7 g of coffee for every
cup.
Use a finer grind.
Use fresh coffee.
Use approx. 7 g of coffee for each
cup.
Clean the shower screen.
Use another coffee bean.
Adjust the coffee grinder (When
changing the coffee beans, changing
the grind can also be necessary.)
Refill water.
Switch on/off the machine.
Make sure that the floater in the
water tank is in the correct position.
(The side of the floater with the
magnet point must face towards the
inside of the machine. The floater
itself must be inserted with the
magnet point on the lower part of
the floater.)
Fix the water tank properly.
Switch to position "1" (=position
direct water connection).
Switch to position "0" (=position
water tank).
Fix the portafilter properly.
Change group gasket and shower
screen.
ENGLISH

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Mechanika iv82044850448227485274

Inhoudsopgave