Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3) Do not actuate the tool unless the
tool is placed firmly against the
workpiece. If the tool is not in contact with
the workpiece, the fastener may be deflected
away from your target.
4) Disconnect the tool from the power
source when the fastener jams
in the tool. While removing a jammed
fastener, the tacker may be accidentally
activated if it is plugged in.
5) Use caution while removing a
jammed fastener. The mechanism may
be under compression and the fastener may
be forcefully discharged while attempting to
free a jammed condition.
6) Do not use this tacker for fastening
electrical cables. It is not designed for
electric cable installation and may damage
the insulation of electric cables thereby
causing electric shock or fire hazards.
˜ Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well
as wear personal protective equipment.
Take the following points into account to minimise
the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions.
Ensure that the product is in good condition
and well maintained.
Keep tight grip on the handles/grip surface.
Maintain this product in accordance with
these instructions and keep it well lubricated
(where appropriate).
Plan your work schedule to spread any high
vibration tool use across a longer period of
time.
14 GB/IE/NI
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this product by
means of this instruction manual. Memorise the
safety warnings and follow them to the letter. This
will help to prevent risks and hazards.
Always be alert when using this product, so
that you can recognise and handle risks early.
Fast intervention can prevent serious injury
and damage to property.
Switch the product off and remove the battery
pack if there are malfunctions. Have the
product checked by a qualified professional
and repaired, if necessary, before you
operate it again.
˜ Residual risks
Even if you are operating this product in
accordance with all the safety requirements,
potential risks of injury and damage remain. The
following dangers can arise in connection with the
structure and design of this product:
Health defects resulting from vibration
emission if the product is being used over
long periods of time or not adequately
managed and properly maintained.
NOTE
This product produces an electromagnetic
u
field during operation! This field may under
some circumstances interfere with active or
passive medical implants!
To reduce the risk of serious or fatal injury,
u
we recommend persons with medical
implants to consult their doctor and the
medical implant manufacturer before
operating this product!
Advertenties
Inhoudsopgave
