Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Setup
Remove all packaging material from the product.
Remove all protective films before using for the first time.
Note: First insert the batteries into the outdoor and pool sensors.
Putting outdoor sensor into operation
•
Open the battery compartment of the outdoor sensor
compartment cover in the direction of the arrow.
•
If necessary, remove the old batteries first.
•
Insert the supplied batteries 2 x 1.5 V AAA R03/LR03 in the correct polarity (+/-).
•
The control LED
splayed.
•
Close the battery compartment of the outdoor sensor
Putting the pool sensor into operation
•
Open the battery compartment of the pool sensor
cover
and sliding the battery compartment cover
arrow.
•
If necessary, remove the old batteries first.
•
Insert the supplied batteries 2 x 1.5 V AA R6/LR6 in the correct polarity (+/-).
•
The display is briefly shown completely and the water temperature
•
Close the battery compartment of the pool sensor
again.
Putting the base station into operation
•
Open the base station's battery compartment
•
If necessary, remove the old batteries first.
•
Insert the supplied batteries 2 x 1.5 V AA R6/LR6 in the correct polarity (+/-).
•
The display is briefly shown completely and a signal tone sounds. The indoor tem-
perature
and indoor humidity
•
Close the battery compartment of the base station
Note: It may take a few minutes for the product to adjust to the environmental condi-
tions and display the correct values.
lights up temporarily and the outside temperature
are then displayed.
- 16 -
by sliding the battery
.
by unscrewing the funnel
in the direction of the
and tighten the funnel cover
.
.
is di-
is shown.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
