Table of contents
Ú
Measures to note ....................................................................... 2
optional)................................................................................................2
Gas connection .......................................................................... 3
the small flame ....................................................................................5
Measures to note
The appliance may only be converted to a different gas type
by an approved specialist, in accordance with the
instructions in this manual.
Incorrect connection and incorrect settings may cause
serious damage to the appliance. The appliance
manufacturer accepts no liability for damage and
malfunctions of this kind.
Pay close attention to the symbols indicated on the rating plate.
If there is no symbol for your country, follow the technical
guidelines that apply in your country when making settings.
Before setting up the appliance, determine the gas type and
pressure in the local supply network. Before using the
appliance for the first time, make sure that all settings have
been made correctly.
Pay attention to local and international rules and regulations.
All connection data can be found on the rating plate on the rear
of the appliance.
Enter the data in the following table:
Product number (E no.),
Manufacturing number (FD),
Enter the factory settings for gas type/gas pressure, as well as
the settings for gas type/pressure that apply after the gas
conversion, in the following table.
E no.
After-sales service
O
Type of gas / gas pressure
Data on the rating plate
Type of gas / gas pressure
Data after gas conversion
The changes made to the appliance and the type of connection
play an important role in ensuring that the appliance operates
correctly and safely.
:
Risk of gas escape!
After connecting the appliance to the gas supply, always
■
check the connection for leak tightness. The manufacturer
2
Ú
I n s t r u c t i o n s f o r c o n n e c t i n g g a s a n d g a s c o n v e r s i o n ( f o r A f t e r - S a l e s S e r v i c e o n l y )
FD no.
Burner ...................................................................................................9
Oven ......................................................................................................9
accepts no responsibility for the escape of gas from a gas
connection which has been previously tampered with.
Do not move the appliance by pulling on the gas pipe
■
Risk of gas leak!
(collector). This could damage the gas pipe.
The appliance must not be moved once it has been installed.
Risk of gas leak!
■
If you do move the appliance once it has been installed,
check that the connection is leak-tight.
Switch off the power and gas supply before carrying out any
work.
This appliance must not be installed on boats or in vehicles.
Choose which side of the appliance to
connect the gas on (* optional)
The gas supply to the appliance can be connected on the left
or right. The side on which the gas supply is connected can be
changed if necessary.
Connect the main gas supply.
If you change the side on which the gas supply is connected,
the gas connection piece on the side that is not being used
must be sealed with a blind plug.
To do this:
Place the new seal in the blind plug. Make sure the seal is
1.
seated correctly.
Secure the gas connection piece to the appliance using a 22
2.
mm spanner and place the blind plug onto the connection
piece using a 24 mm spanner.
Once the side on which the gas supply is connected has been
changed, check that the connection is leak-tight. See the
section entitled "Leak testing" for more information about this.