Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10. Starting up
10.1 Fitting the pushing device onto the
wheelchair (Fig. 10.1)
Open the lock by pressing the release button (M) on
the lever on both sides and plug the connector into the
docking pin (D) on the wheelchair frame. Ensure that the
lock is fully clicked into place.
D
17
CAUTION!
The pushing device may only be used with the delivered
docking system and the suitable docking pins for your
wheelchair.
The pushing device must be handed over ready to use
from Sunrise Medical or an authorised Sunrise Medical
dealer. Changing the bracket for the pushing aid must
only be carried out by Sunrise Medical or the authorised
health care specialist.
WARNING!
As with all moving parts, there is a risk that fingers and /
or clothing could become trapped. Please always handle
carefully.
10.2 Fitting the back pack onto the wheelchair
(Fig. 10.2)
Connect the four corners of the back pack with the buckle
(T1) of the retaining straps. Adjust the straps (T2) to the
required width for your wheelchair. Any surplus strap can
be fixed using the retaining clips (T3).
T1
T3
Empulse R20
Fig. 10.1
M
Fig. 10.2
T2
10.3 Mounting the control unit (Fig. 10.3)
Fix the control unit to the bracket using the wing bolt (24).
The optimal position can be set for the pushbutton (W)
by undoing or removing the screw fitting (21) and the
display can be adjusted by undoing the screw (21). Then
re-tighten all screws.
S
R
24
W
21
By undoing the wing bolt (24), the control unit (T) can be
fully removed and stored in the back pack. To do this, pull
the control unit (T) through the rear zip fastening of the
back pack and store it in the right back pack pocket.
14
T
V
21
English | Rev. G
Fig. 10.3
Advertenties
Hoofdstukken
Inhoudsopgave
