Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
When you first turn on Console power, after all installation procedures have been completed, the Console will
flash "CAL" in the RATE display and "US" in the DATA display. This means you must "calibrate" or program the
Console before it can be operated.
(This is a one time operation which does not have to be repeated unless you disconnect your battery wires.
Turning OFF the POWER ON/OFF switch does not affect the Console memory. All data is retained). The follow-
ing steps must now be followed.
If an entry selection error is made during steps 1, 2, 3, or 4, the Console can be reset by depressing
20 seconds (Data displays US and RATE displays CAL.).
1. Displaying US, SI or TU
a. Depressing momentarily
b. Depressing momentarily
c. Depressing momentarily
2. Selecting US, SI or TU
a. To select US, SI, or TU, step
b. Momentarily depress
3. Displaying SP1 or SP2
a. Depressing momentarily
b. Depressing momentarily
4. Selecting SP1 OR SP2
a. To select SP1 or SP2, step with
b. Momentarily depress
5. Enter width in inches (cm) of BOOM 1 in the key labeled:
6. Enter width in inches (cm) of BOOM 2 in the key labeled:
width of BOOM 2.
7. Enter width in inches (cm) of BOOM 3 in the key labeled:
for width of BOOM 3.
16
INITIAL PROGRAMMING OF CONSOLE COMPUTER
Steps the DATA display from US (acres) to SI.
Steps the DATA display from SI (Hectares) to TU.
Steps the DATA display from TU (1000 sq ft) to US.
until the desired code is displayed in DATA display.
the DATA display will now display SP1.
steps the DATA display from SP1 (wheel drives, etc.) to SP2.
steps the DATA display from SP2 (radar sensor) to SP1.
until desired code is displayed in DATA display.
the DATA display will now display 0.
If there is only one boom, enter "0" for
If there is only one or two boom, enter "0"
for
Advertenties
Hoofdstukken
Inhoudsopgave
