Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TROUBLESHOOTING
Symptom
L appears in the display (from
the left zones).
n
appears in the display.
Some touch controls are not
working.
Flash symbol in the display.
Error code U400 and/or
continuous beep.
Code G on downdraft display
(alternately with the selected
power.)
Code S on downdraft display
(alternately with the selected
power.)
Flashing 8 on downdraft
display.
Other error codes.
Possible cause
Lock function activated.
The link function is activated.
You have pressed two or more
keys at the same time.
The control panel is dirty or
has water lying on it.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Grease filter 30
operating hours.
Carbon filter 120
operating hours.
Excess liquids inside the
downdraft interior.
Defective generator.
Solution
Touch simultaneously the
cooking zone key from the
left rear zone and the minus
(-) key until you hear an
audio signal. Then touch the
minus (-) key to stop the lock
function.
Deactivate the link function.
Do not operate more than one
key at the same time.
Clean the control panel.
Let your connection be
changed.
Clean the grease filter.
Use the downdraft clean
function.
Replace the carbon filter.
Use the downdraft clean
function.
Dry and clean the downdraft
interior (see: Presence of
liquids inside the device).
Contact the service
department.
EN 23
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
