Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
IE
least as high as what has been
specified on the name plate of
the device.
- Do not use any broken, cracked,
or otherwise damaged grinding
discs.
- Never operate the device with-
out protective equipment.
- Support plates or workpieces to
reduce the risk of kickback from
a jammed cutting disc. Large
workpieces may bend under
their own weight. The workpiece
must be supported on both sides
of the disc, near the cutting disc
as well as at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Information on replace-
ment:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc is the
same or higher than the nominal
rotation speed of the device.
• Ensure that the grinding disc
dimensions match those of the
device.
• Only use flawless grinding discs
(ringing test: when you strike the
grinding disc with a plastic ham-
mer, it results in a clear sound).
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs with a hole that is too
large fit the device.
• Do not use any saw blades.
20
All manuals and user guides at all-guides.com
• To clamp the grinding tools
only use the clamping flange
provided. The pads between the
clamping flange and the grind-
ing tools must be made of elastic
materials e.g., rubber, soft card-
board etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Turn off the appliance and, before
doing any servicing, remove the
battery.
Wear protective gloves when chang-
ing the grinding discs in order to
avoid cutting damages.
The grinding disc nut must not be
screwed too tightly in order to
avoid breaking the disc and nut.
Turning on and off
1. Press the on switch to start the device.
Press the on/off switch (5).
2. To turn it off, release the on-off button.
The device turns off.
After switching on the device, wait until the
device has reached its max. speed. Only
then should you start with the work.
The disc still runs even after
the device has been switched
off. Risk of injury.
Trial run:
Always carry out a trial run before carry-
ing out your first grinding procedure and
after every disc replacement. Switch the
device off immediately if the grinding disc
is not rotating smoothly, if considerable
Advertenties
Hoofdstukken
Inhoudsopgave
