Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Programming the daily run times
To program the desired UP run time, press the UP button for at least 6
seconds. The indicator lamp flashes briefly three times. This drive command
will now be repeated every 24 hours.
To program the desired DOWN run time, press the DOWN button for at least 6
seconds. The indicator lamp flashes briefly three times. This drive command
will now be repeated every 24 hours.
Overwriting the run times is possible at any time. Repeat the
programming phase to set the new desired daily run time.
Deleting the daily run times
To delete the UP and DOWN run time, press the reset button
All run times, intermediate positions and tilt positions/ventil-
ation slots can be deleted by pressing the reset button (with
a ballpoint pen or similar object).
Programming intermediate position
Prerequisite: The roller shutter/blind is in the upper limit position.
1.
Press and hold the intermediate position programming button
2.
Also press the DOWN button until you reach the desired intermediate po-
sition. Adjustments can be made using the UP button or DOWN button.
3.
Release the intermediate position programming
diate position is now saved.
The indicator lamp flashes briefly three times.
Deleting intermediate positions
Press the intermediate position programming button
seconds. The intermediate position is now deleted.
The indicator lamp flashes briefly three times.
22 - en
Programming
.
button. The interme-
for more than 5
Advertenties
Hoofdstukken
Inhoudsopgave
