Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Explanation of functions
Manual/Automatic slide switch
In slide switch position " " only manual drive commands can be performed
(e.g.: UP, STOP, DOWN via button actuation).
In slide switch position " " automatic drive commands are performed (time).
Indicator lamp
Confirms the run time settings by flashing 3 times.
Selection of the roller shutter/blind
Roller shutter/blind mode can be set via the coding switch on the rear of the
device.
When using the roller shutter function, the roller shutter moves in maintained
operation after a travel button has been operated.
RESET button
All run times, intermediate positions and ventilation/tilt positions can be de-
leted by pressing the RESET button (with a ballpoint pen or similar object).
Intermediate position
The intermediate position is a freely selectable position of the roller shutter/
blind between the upper and lower limit positions. Once programmed, this in-
termediate position can be travelled to from the upper limit position.
To do so, press the DOWN button briefly twice in succession.
Ventilation/tilt
The ventilation/tilt position is a freely selectable position of the roller shutter/
blind between the lower and upper limit positions. This function allows you to
open the roller shutter from the lower limit position up until the ventilation slots
are opened. With the blind, the slats can be tilted.
To do so, press the UP button briefly twice in succession.
Setting the roller shutter or blind
Roller shutter/blind mode can be set via a coding switch on the rear of the
control panel.
20 - en
Advertenties
Hoofdstukken
Inhoudsopgave
