Setting Tool; Wind Threshold Regulator (In Connection With A Suitable Sensor From The Controller Manufacturer) - Becker Centronic SunWindControl SWC441-II Montage- En Gebruiksaanwijzing

Voor zon-wind-besturing

Inhoudsopgave

Advertenties

Beschikbare talen

Setting tool

When used properly, the rib on the handle of the tool serves as an orientation

aid for setting the threshold value.

Rib

Insert the tool in the threshold regulator.

Turn the threshold regulator as far as the left stop.

Remove the tool.

Now insert the tool such that the rib points in the minus direction (-).

Turn the tool in the plus direction (+) until the desired threshold value is

reached.

Wind threshold regulator (in connection with a suitable

sensor from the controller manufacturer)

You set the wind threshold value with this regulator (between about 2 m/s and

22 m/s).

The wind threshold value can be adjusted in 11 steps. When slowly turning the

regulator, the tubular drive clicks to indicate the setting changes.

- Left stop

+ Right stop

Changes made to the threshold value are transferred immediately.

When setting the threshold, ensure that no button is

pressed. When the wind speed exceeds the set wind

threshold value, the sun protection system retracts and re-

mains closed. The sun protection system can only be exten-

ded again after the wind speed has remained below the

threshold value for approx. 15 minutes.

Stage 1, retract at low wind

Stage 11, retract at very high wind

19 - en

Inhoudsopgave

Advertenties

Inhoudsopgave