Learning The Master Transmitter; Learning Additional Transmitters - Becker Centronic SunWindControl SWC442-II Montage- En Gebruiksaanwijzing

Voor zon-wind-lichtbesturing

Verberg thumbnails Zie ook voor Centronic SunWindControl SWC442-II:

Inhoudsopgave

Advertenties

Beschikbare talen

Assembly and Operating Instructions

2) Learning the master transmitter

a) Put receiver into learn mode

Note

The master transmitter is the very first transmitter programmed on a

receiver. In contrast to subsequently programmed transmitters, the

master transmitter enables, among other things, the setting of limit po-

sitions (for drives with integr. radio receiver) and the programming or

deleting of further transmitters.Any transmitter which has a separate

UP, STOP, DOWN button and a programming button can be a master

transmitter.

Always follow the installation and operating instructions of the receiver.

Use a suitable cylindrical tool (e. g. ball-point pen) to actuate the pro-

gramming button on the transmitter.

• Switch off the receiver's power supply and reconnect after 5 seconds.

• Actuate the programming button or the radio-controlled receiver switch.

The receiver will then be in "Learn" mode for 3 minutes.

b) Learn master transmitter

Press the programming button of the master transmitter in programming mode

until the receiver acknowledges successful programming.

The learn process is now complete.

3) Learning additional transmitters

a) Press the learn button of the master transmitter until acknowledgement is

given by the receiver.

b) Now press the learn button of the new transmitter until acknowledgement is

given by the receiver

c) Then press the learn button of the new transmitter to be learnt once again.

The receiver will indicate when the learn process has been successfully com-

pleted.

The maximum radio range is up to 25 m outside and inside the building and up

to 350 m in the open.

Inhoudsopgave

Advertenties

Inhoudsopgave