Factory Setting; Programming The Remote Control; Learning The Light Function - Becker Centronic SunWindControl SWC442-II Montage- En Gebruiksaanwijzing

Voor zon-wind-lichtbesturing

Verberg thumbnails Zie ook voor Centronic SunWindControl SWC442-II:

Inhoudsopgave

Advertenties

Beschikbare talen

Light controller push button

Use the light controller push button to switch the lighting set on and off, or to

dim it.

If the light controller push button is pressed for less than 0.5 seconds, the light-

ing set is either switched ON or OFF.

If the light controller push button is pressed for longer than 0.5 seconds, the

lighting set is dimmed in a sequence of commands, e.g. maximum value, mini-

mum value etc.

Sun threshold value: Intermediate position (25KLux)

Wind threshold value: Left limit stop (2 m/s)

Programming the remote control

Caution

Before programming the transmitter, please check whether the thresh-

old control switches are set to the factory setting. When programming

the transmitter, ensure that you are not located in the operating area of

the sun protection system. Please refer to the operating instructions

for the receiver.

1) Learning the light function

a) Put the light receiver into learn mode

• Switch off the receiver's power supply and reconnect after 5 seconds.

The receiver will then be in "Learn" mode for 3 minutes.

b) Learning the light function

Press the light controller push button and within 3 seconds the "Learn" key and

keep both buttons pressed until the receiver indicates that the learn process has

been successfully completed.

The learn process is now complete.

Factory setting

Inhoudsopgave

Advertenties

Inhoudsopgave