Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7. Check List for Commissioning
What must be done:
a) Checking all Screw Connections and Wheel Nuts
b) Removing and Replacing the Car Body
c) Check Alignment and Tooth Backlash of Drive
d) Commissioning the RC System
e) Failsafe module
f) Checking the Range of the Remote Control Transmitter
g) Servo function Check
h) Checking the Basic Carburettor Setting
i) Starting the Engine
j) Break-in instructions for the Engine
Attention! Positions (front, rear, right, left) always refer to the vehicles centre line in forward direction of motion!
a) Checking All Screw Connections and Wheel Nuts
Check before each use:
• All wheel nuts and screw connections must be tight.
• The servo control lever must fit tight on the servo shaft.
• Install the air filter.
• Check the tightness of hose connections and tank lid before each use.
• The cables must be installed properly.
Engine vibrations and shocks during drive operation can loosen parts and screw connections.
b) Removing and Replacing the Chassis
To remove the car body, remove the body pins.
Now remove the car body
To replace the car body, insert the body holder into the holes drilled into the car body. Now attach the car body again to the body pins.
38
Advertenties
Hoofdstukken
Inhoudsopgave
