Test Mode; Factory Default Settings - Becker Centronic SunWindControl SWC442-II Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic SunWindControl SWC442-II:

Inhoudsopgave

Advertenties

Beschikbare talen

When setting the threshold, ensure that no button is

pressed. If the set sun threshold value is exceeded, the sun

protection system extends after a delay of up to 5 minutes.

The sun protection system automatically retracts after the

sunshine level has been continuously below the threshold

value for about 15 minutes.

TEST mode

The TEST mode is activated by adjusting the threshold value. It automatically

ends after about 15 minutes. In TEST mode, the time for which the wind is

monitored is shortened.

Light control button

The light control button allows you to switch the lighting equipment on or off,

and to dim it.

If the light control button is held down for less than about 0.5 seconds, the

lighting equipment will switch ON or OFF.

If the light control button is held down for longer than 0.5 seconds, the lighting

equipment dims according to the command sequence of maximum value,

minimum value, etc.

Sun threshold value

Wind threshold value

22 - en

Medium setting (about 25 kLux)

Left stop (about 2 m/s)

Inhoudsopgave

Advertenties

Inhoudsopgave