Explanation Of Functions; Setting Tool - Becker Centronic SunWindControl SWC442-II Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic SunWindControl SWC442-II:

Inhoudsopgave

Advertenties

Beschikbare talen

Explanation of functions

Manual/Automatic slide switch

In slide switch position " " only manual drive commands and alarm signals can

be performed (e.g.: RETRACT, STOP, EXTEND via button actuation and wind

alarm).

In slide switch position " " automatic drive commands are performed (e.g.

sun protection, ...).

The automatic sun protection functions are interrupted if a manual drive com-

mand is carried out when in automatic mode. These functions are automatic-

ally re-activated if upper/lower threshold limits are violated, following retrac-

tion, or if the slide switch is switched from " " to " " and back to " ".

Channel

The channel of a transmitter can be programmed into one or more receivers.

One receiver is operated through an individual command, several receivers

through a group command.

Channel indicator lamp

A radio signal is indicated by the channel indicator lamp lighting up. When the

battery starts to lose power, the channel indicator lamp flashes when transmit-

ting. The transmission strength and the radio range decrease as battery power

declines. If the channel indicator lamp no longer lights up when a button is

pressed, the battery must be replaced.

When used properly, the rib on the handle of the tool serves as an orientation

aid for setting the threshold value.

Rib

20 - en

Inhoudsopgave

Advertenties

Inhoudsopgave