Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
This product may be used by children age
8 years and up, as well as by persons with
reduced physical, sensory or mental capacities,
or lacking experience and / or knowledge,
so long as they are supervised or instructed
in the safe use of the product and understand
the associated risks . Children should not be
allowed to play with the product . Cleaning and
user maintenance should not be performed by
children without supervision .
DANGER OF SUFFOCATION! Children
could swallow and choke on small included parts
(e .g . screws) . Keep children away from the work
area during assembly .
Danger to life by electric shock
Always check the product for damage before
connecting it to the mains . Never use the product
if it shows any signs of damage .
Prior to installation, verify that the mains voltage
on site corresponds with the operating voltage
required for the product (230 V∼) . Otherwise do
not install the product .
Only use 230 V∼ LED bulbs with a E27 base
and a maximum output of 8 W .
The LED bulb is not dimmable .
DANGER OF INJURY! Check any LED bulb
for damage immediately after unpacking . Do not
fit a defective LED bulb into the product .
CAUTION! DANGER OF BURNS
DUE TO HOT SURFACES!
Ensure the product has been switched off and
allowed to cool before you touch it . In this way
you will avoid the danger of burns . LED bulbs
develop a great deal of heat .
Replace a defective bulb immediately . Before
replacing the LED bulb always switch off the
electricity supply of the product .
Allow the product to cool for at least 15 minutes
before replacing a defective LED bulb .
˜ Before installation
Note: Remove all packaging materials from the
product .
Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations . This
person must be familiar with the properties of the
product and the connection regulations .
Before installation ensure that the circuit, to which
the product will be connected, is not energised .
To do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 setting) (see Fig . A) .
Use a voltage tester to verify the de-energised
status .
The included mounting material is suitable for
ordinary solid concrete flooring . Check which
mounting material is suitable for your chosen
mounting surface . If necessary, seek expert
advice .
The length of the external power cable 8
should not be less than 120 cm .
˜ Installation
Make sure you will not be drilling into electrical, gas
or water lines inside the ground . Use a power drill
to drill the holes into the ground . Always observe all
safety instructions for the power drill in the manual for
the power drill . Death or injury due to electric shock
may otherwise result .
Open the cover 2 by releasing the locking
screws 5 from the lamp body 1 with a
crosshead screwdriver (see Fig . B) .
GB/IE/NI
7
Advertenties
Hoofdstukken
Inhoudsopgave
