Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Hold the base 4 and mark the fastening holes
(see Fig . C) .
Now drill the fastening holes (Ø approx . 6 mm,
depth approx . 55 mm) . Ensure that you do not
damage the electrical supply line .
Place the dowels 6 into the drill holes (see
Fig . D) .
Attach the lower pole 3 on the base 4 (see
Fig . E) .
Note: The lower pole should have an inner
screw thread on one side, and an outer screw
thread on another side .
Attach the upper pole 3 on top of the lower
pole (see Fig . F) .
Note: The upper pole should have an inner
screw thread on one side only .
Slide the external power cable 8 through the
assembled base 4 and the pole 3 into the
terminal block housing 9 (see Fig . G) .
Connect the connection cable of the product to
the external power cable 8 by means of the
terminal block 7 (see Fig . G) .
Also ensure that the colour connection of the
wires is correct when connecting (L = black or
brown, N = blue or white) .
Now connect the earth wire (green-yellow) to the
marked earth terminal
Pull the external power cable 8 so the terminal
block 7 is fully covered by the terminal block
housing 9 . Use a screwdriver to fasten the
plastic grub screw 11 at the bottom of the
terminal block housing to fix the terminal block
position (see Fig . H / a) .
Lower down the terminal block housing so it is
covered by the upper pole (see Fig . H / b) .
8
GB/IE/NI
(see Fig . G) .
Attach the lamp body 1 on the upper pole .
Fasten the metal grub screws 10 to fix the
position (see Fig . H / c) .
Attach the product to the dowels 6 which are
placed on the floor . Tighten the base 4 with
mounting screws 12 (see Fig . I) .
Insert the LED bulb 13 into the bulb holder 14
carefully with a cloth . Tighten the LED bulb in a
clockwise direction (see Fig . J) .
Place the cover 2 on the lamp body 1 and
tighten it with locking screws 5 (see Fig . K) .
Reinsert the fuse or switch the circuit breaker
back on (see Fig . L) . Your product is now ready
to use .
˜ Replacing the LED bulb
m CAUTION! RISK OF ELECTRIC SHOCK!
Replacing the LED bulb 13: Disconnect the
product from the mains circuit . To do this, remove
the fuse or switch off the circuit breaker in the
fuse box (0 setting) (see Fig . A) .
Allow the product to cool completely .
Remove the cover 2 from the lamp body 1 .
Remove the defective LED bulb 13 from the
bulb holder 14 by turning it in an anti-clockwise
direction .
Use a dry, lint-free cloth to replace the LED bulb
13 .
Insert a new LED bulb 13 in the bulb holder 14 .
Tighten the LED bulb in a clockwise direction .
Place the cover 2 over the lamp body 1 and
screw tight .
Reinsert the fuse or switch the circuit breaker
back on (see Fig . L) .
Advertenties
Hoofdstukken
Inhoudsopgave
