Advertenties
Beschikbare talen
Beschikbare talen
NL UK
The "Easymatic" automatic version
External buzzer output: The connection for an external buzzer, for extra safety, will go together with the
internal buzzer.The maximum consumption of this buzzer may not exceed 0,5 Amp.
Tow hitch safety feature: Pin 9 of the 13 pole tow hook socket is a permanent power cable.This cable has to be
connected to pin 6 of the ECU. Pin 13 of the tow hook socket is the negative cable, this has to be connected to
pin 5 of the ECU. When the connector of the caravan is attached to the socket of the tow hook , the power of
12volts from pin 9 will disengage the drive rollers from the tyres. Activation of the drive rollers during driving
will not be possible. If you forget to disengage the drive rollers from the caravan tyres, the 12 volts of Pin 9
will activate the electronic system automatically to disengage the drive rollers from the caravan tyres.
This unique SimPark® safety provision makes it impossible to accidentally drive away with the drive rollers
engaged.
Quicker response time
The motors are now stopped immediately when they are shut off. This feature, in combination with the
Slow-Start receiver, makes extremely accurate positioning possible. Due to the new features, the remote
control is not compatible with the "standard" SimPark® and vice versa!
Keeping the drive rollers clean
Keep your SimPark® caravan mover, and particularly the drive rollers, free of grit, sharp particles, bits of wood,
grease, mud and other contaminants. Use tap water and a brush to clean the friction rollers.
Emergency release valve
In the event of a failure in which the drive rollers will not return to the retracted position, release valve stop
must be used. By opening the release valve a 1/4 turn, the pressure in the system system will be reduced
so the drive rollers return to the retracted position. The emergency stop valve is located on the hydraulic
pump. This pump is installed underneath your caravan, in the middle. The release valve is accessible via the
hole in the housing, which is covered by a black rubber cap. Remove the rubber cap. Using the provided
M6 allen key, and open the bolt a 1/4 turn. As soon as the drive rollers have reached the fully-retracted
position, the release valve can be closed again.
Technical details
Motors
12 volt DC with gear box
Torque
25-45 Nm (under normal circumstances), maximum 70 Nm.
Speed
0.52 km/hour
Weight
38 kg for the manual version / 40 kg for the Easymatic version
Battery
Recommended: 105 Amperes semi traction (sold separately)
Use
Caravans to a max. of 2500 kilograms, A 20% incline can easily taken with Caravans of 2000 kg.
Material used Stainless steel and Aluminium
Subject to technical changes
26
Advertenties
Hoofdstukken
