Advertenties
Beschikbare talen
Beschikbare talen
NL UK
1. PARTS LIST
1 x Left and right motor unit
1 x Cross bar, 2x mounting clamps assemblies
1 x Remote control with 2x AA batteries, 1 x ECU
1 x 1 mtr. red cable 10 mm
6 x Terminal connectors, 4 x tie wraps, 1 x distance measuring block of 1.5 cm
1 x Extendable wrench (only manual version)
1 x 5 mtrs. flexible protection hose
1 x Caution sticker "Release rollers"
Easymatic version:
1x Hydraulic system, including protection cover
1x Multiplex plate 15x15 cm
1x 1x 1 mtr. red cable 1 mm
1x 1x 4 mtr. purple cable and 1x 4 mtr. brown cable 1 mm
1x Allen key M6
2. CROSS BAR AND MOUNTING CLAMPS
Installation instructions
Instructions to install the "SimPark®" caravan mover
•
Measure the distance between the chassis at the location of the installation.
•
Measure the length of the cross bar and mark the middle with a marker (72.5 cm).
•
Put the left and right motor unit together by means of the cross bar and beware that the marked point is
in the middle. (See fig.1)
fig. 1
•
SimPark® got supplies of mounting plates and clamps for different types of chassis.
•
Place the mounting clamp (see fig. 2 ) over the cross bar and put the plate on top of it.
•
Use a support to press the parking device to the chassis of the caravan and push the mounting clamps
aside to the caravan chassis.
/ 1x 1 mtr. black cable 10 mm
2
2
/ 1x 10 Amp. fuse / 1x fuse holder / 1 x power main switch
L. max = 2450 mm
2
2
L. min = 1870 mm
Mark
16
Advertenties
Hoofdstukken
