Download Inhoudsopgave Inhoud Print deze pagina

Stopping Or Changing A Wash Cycle; At The End Of The Wash Cycle; Cycle Selection Table - ETNA EVW8262 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

OPERATION

Stopping or changing a wash cycle

At the end of the wash cycle

Cycle selection table

Cycles
3-in-1
3 in 1
EN 12
1. Open the door.
2. Press the start/reset button more than three seconds.
The program stops. The indicator light goes out.
3. Press the start/reset button again and select the desired washing
program with the selector button.
4. Close the door.
The indicator light will light up and the washing program starts
immediately.
Attention!
A cycle that has already begun can only be changed in the start-up
phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
Warning!
It is dangerous to open the door completely when washing, because the hot
water may scald you.
Once the wash cycle has completed, an audible signal will sound for
eight seconds.
1. Switch the appliance off using the On/Off button.
2. Open the door.
3. Wait a few minutes before unloading the dishwasher. The dishes
and cutlery will still be very hot immediately following the end of the
cycle. There is a chance that dishes may break as a result of the
heat. Moreover, the dishes dry better when allowed to stand for a
few minutes.
Information
For normally soiled loads. Use
multifunctional detergent.
Cycle process
Pre-wash (50 °C)
Wash (55 °C)
Rinse
Rinse (65 °C)
Drying
Time in min.
160

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Inhoudsopgave