Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The removal of the doors is now finished.
a) Install the removed parts on the opposite
side of the appliance. Pull the door socket,
as shown in the following figure, and install
it in the respective position on the other
side.
b) Remove the screws from the stopper, as
shown in the following figure, and install it
on the opposite side of the door.
c) Remove the shaft and the two stoppers
from the lower hinge and install it in the
position, as shown in the following figure.
Install the refrigerator and freezer doors on the
opposite side.
a) Remove the adjustable stand in the front,
as shown below. Then, install the lower
hinge on the other side of the fridge and
tighten the screws.
Step 3
b) Install the shorter adjustable stand in the
front on the side, where the lower hinge is.
By turning the stand, you can adjust the
height on this side of the appliance until it
is levelled out.
a) Attach the freezer door, turn the middle
hinge 180° and then install it on the oppo-
site side of the appliance. Attach the middle
hinge with the 3 corresponding screws.
b) Attach the refrigerator door and install the
upper hinge on the opposite side of the ap-
pliance. Attach the upper hinge with the 4
corresponding screws. Also, attach the loop
of the ground cable with one of the four
screws. Afterwards, connect the cable link.
Attach the upper hinge cover with a screw.
- 30 -
Step 4
Step 5
Advertenties
Inhoudsopgave
