Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Do not set the temperature lower than
necessary. More details on temperature
settings can be taken from the chapter
'Controls and Display'.
Operation Noises
There might be some typical operation noises
when the appliance is turned on. These are:
• Noise of the electric motor is arising from
the working compressor. When the com-
pressor starts to operate, then the noises
get slightly louder for a short time.
• Noises in the tubes of the circulation of the
refrigerant.
Change the Door Stop
• If necessary, the door can be changed from
right- to left-hinged.
• Warning! Before you work on the appli-
ance, always pull the mains plug out of
the point.
• In order to avoid damages to persons and
property, execute the change of the door
stop with two persons.
• We recommend leaving the change of the
door stop to experts.
• Before you start with the modifications,
here is some general info:
ū Always pay attention to the number of
shims on the bearing pins and screws.
ū Position the doors always so that they
close tightly.
a) Loosen the screw from the cover of the
hinge and remove the cover.
b) Unplug the cable. Unscrew the 4 screws
that hold the upper hinge and remove it.
Take off the loop on the ground cable of the
hinge. Insert the cable connection in the
opening on the top of the appliance. Take
off the door jack and the cover of the small
end caps.
c) Put the door jack and the cable connection
in the opening on the door and then attach
the small end cap.
Step 1
- 28 -
Advertenties
Inhoudsopgave
