Advertenties
Beschikbare talen
Beschikbare talen
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction
hose to the back away from the machine.
Power tools have to be inspected by a specialist in regular intervals.
Do not touch rotating parts.
Personen unter 16 Jahren dürfen das Gerät nicht benutzen.
During use, the operator and other persons standing nearby have
to wear suitable ear protectors, a dust mask and protection
goggles.
Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
Always carry the tool at the transport handle (1) intended for it. Therefor
put the floor guiding device in upright position.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Floor guiding device
Handle assembly
2
Before initial operation the handle (2)
has to be mounted to the floor guiding
device.
Put the handle through the fastening
3
clamp at the device, fix it with clamp
lever (3), following push the rubber
handle onto the tube.
Using a rubber mallet, carefully hit on
the rubber handle until it is completely
on the tube.
19
Advertenties
