Advertenties
Beschikbare talen
Beschikbare talen
Cement
The stirrer is well suited to mix ready-mixed mortar, plaster and the like.
Automix is not designed to mix concrete or mortar with medium-size gravel
and admixtures.
To prepare ready-mixed mortar or plaster, process as described in section
'Floor and Wall Tile Adhesives' above.
Since mortar is heavily hygroscopic, in view of excessive mix hardening it is
necessary to carefully observe the quantities of adhesive, cement or
additives for the desired mix.
Epoxy Resins
To process epoxy resins, it is necessary to check the viscosity and the
specific weight of the mix to be prepared in order to avoid overload of the
Automix tool.
Fill the quantities of resin, hardener and powder as advised by the producer
into the bucket.
Carefully mix the components in order to avoid formation of bubbles or
clumps
Paints
Fill the paint into the bucket and add the quantity of water or admixtures
required for the solution.
IMPORTANT!
The use of chemicals or solvents may impair the properties
!
of the bucket.
Before using the Automix tool, check the products to be
mixed for compliance with the tool manufacturer's
requirements.
Removal of the Bucket
Switch the tool off and wait until the stirrer basket has stopped.
Open the locking of the tool arm.
Move the tool arm out of the bucket.
Lift the bucket out of the holder of the stand.
Care and Maintenance
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points always have to be
observed:
18
Advertenties
