Advertenties
Beschikbare talen
Beschikbare talen
Tool Protection
Inadequate use may result in damages.
Therefore, it is strictly required to observe the following instructions:
Use only stirring baskets recommended by the manufacturer.
Do not stress the tool to such a extend that it stops by itself.
In order to protect user and motor, the Automix is equipped with a
mechanical overload protection.
In case of sudden blocking of the stirring rod, the mixing spindle is
mechanically disengaged from the motor by means of a clutch.
In order to maintain the efficiency, the clutch should slide 2 seconds max.
through.
In case of considerable wear, it has to be replaced by an
authorised service workshop.
Switching on and off
The tool may be started only with put-up and locked tool
arm. After having the tool switched off, the locking may
be opened and the tool arm put down only after the
stirrer basket has stopped.
Prepare the mix as follows:
Always start the tool without load.
Depending on the material to be processed, proceed as follows:
Floor and Wall Tile Adhesives
Carefully read the instructions on the material bag.
To prepare the desired quantity of adhesive, fill the required quantity of
water into the bucket.
Switch the tool on. Add the content of the first bag (25 kg) with a feed of
approx. 10 kg/min through the protective grid into the bucket.
Continue to do so in an uninterrupted and regular way with the second bag
(25 kg).
So you can avoid clumping of the mix.
If required, allow the adhesive to stand for 5 to 10 min, and then mix again
for some minutes.
Use
Insert the motor head with the stirrer basket into the
bucket and lock it by turning the knurled screw in the
direction of the arrow.
For insert the stirrer basket into the bucket, please
see that the stirrer is positioned across the tool arm.
17
Advertenties
