Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Storage and transportation
■
Store the tool in a safe location.
■
Store the tool and accessories in a safe location that is protected
against naked flames and sources of heat/sparks, such as gas-powered
water heaters, dryers, oil stoves or mobile heaters, etc.
■
Ensure that the protective guard
free of cutting residue during storage.
■
The plastic cover for the 3-tooth cutting blade
transport and storage.
■
Always switch the tool off before performing any maintenance work
and remove the spark plug connector
Storing the tool
The tool must be prepared for storage if it is to be stored for longer than
30 days. Otherwise the residual fuel in the carburettor will evaporate and
leave a gooey sediment. This may make starting the tool more difficult and
result in expensive repair work.
1.) Remove the filler cap
to relieve any pressure in the petrol tank
Carefully empty the petrol tank
2.) To remove all fuel from the carburettor, start the engine and let it run
until it stops.
3.) Allow the engine to cool for about 10 minutes.
4.) Remove the spark plug (see section "Spark plug maintenance").
5.) Add 1 teaspoon of 2-stroke oil to the combustion chamber. Pull the
starter pull cord
several times to wet all mechanical parts with oil.
Replace the spark plug.
NOTE
■
Store the tool in a dry place and away from possible ignition sourc-
es.
Start-up after storage
1.) Remove the spark plug (see section "Spark plug maintenance").
2.) Pull the starter pull cord
quickly in order to remove any excess oil
from the combustion chamber.
3.) Clean the spark plug and observe the correct electrode gap on the
spark plug.
4.) Fill the petrol tank
. See the section "Fuel and oil".
Transport
■
If you are planning on transporting the tool, empty the petrol tank
explained in the section "Storage".
PBK 4 A2
, the strimmer
and the engine are
must be refitted for
.
.
Troubleshooting
Engine unit
Problem
Possible cause
The engine does
Incorrect start-up process.
not start.
Incorrect adjustment
The engine starts
of the choke lever
but does not run
at full power.
Contaminated air filter.
The engine does
Incorrect spark plug gap.
not run smoothly.
Soot deposits or
Incorrect carburettor
wetness on the
adjustment.
spark plug.
.
Pole pruner
Problem
Possible cause
Engine is
Hedge trimmer attachment
running, saw
or pole pruner attachment
is not connected properly
chain
does
to the engine unit.
not move.
Saw chain
No progress.
heating or is sagging.
Hedge trimmer
Problem
Possible cause
Hedge trimmer attachment
Engine is run-
or pole pruner attachment
ning, blades do
is not connected properly
not move.
to the engine unit.
as
Troubleshooting
Follow the instructions
regarding starting.
Set the choke lever
.
to "
".
Clean air filter.
Clean the spark plug
and adjust the spark
plug gap or replace
the spark plug.
Clean the spark plug
or replace it with a
new spark plug.
Troubleshooting
Check assembly.
Top up the oil and
regrind, replace
is dry/over-
or tighten the saw
chain
.
Troubleshooting
Check assembly.
GB │ IE │ NI
│
15
■
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
