Programming Additional Transmitters; Checking That The Running Direction Is Correct; Changing Direction Of Rotation Via Master Transmitter - Becker VarioControl VC320 Gebruikers- En Montagehandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Programming additional transmitters

In addition to the master transmitter, up to 15 further trans-

mitters (of which a maximum of three can be sensors) can be

programmed in the radio receiver.

Press the programming button of the master transmitter for 3 seconds.

▻ The receiver confirms.

Now press the programming button of a new transmitter which has not yet

been programmed in the radio receiver for 3 seconds. Doing so activates the

programming mode of the radio receiver for a new transmitter for 3 minutes.

▻ The receiver confirms.

Now press the programming button of the new transmitter you wish to pro-

gram again for 3 seconds.

▻ The receiver confirms.

► The new transmitter has now been programmed.

Checking that the running direction is

It is only possible to change the rotation direction within 15

minutes after switching on the power.

Press the UP or DOWN button

▻ The shading solution runs in the desired direction.

► The running direction is OK.

If the shading solution runs in the wrong direction, the running direction

must be changed. Proceed as follows:

26 - en

correct

Inhoudsopgave

Advertenties

Inhoudsopgave