Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9. Remove the
Coin cell
battery.
10. Remove the
Inner
frame.
11. Remove the heatsink.
12. Remove the
system
fan.
Steps
1. Peel the adhesive tape and disconnect the touch screen cable from the connector on the system board [1].
2. Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [2].
3. Lift the eDP cable bracket from the system board [3].
4. Disconnect the eDP cable from the system board [4].
5. Disconnect the following cables:
a) Speaker cable [2].
b) LED board cable [1].
c) touchpad cable [3].
6. Remove the two (M2.5x4) screws that secures the system board [1].
7. Peel the adhesive tape and disconnect the cable from the connector on the system board [1].
8. Disconnect the sensor board cable from the connector on the system board [1].
62
Onderdelen verwijderen en plaatsen
Advertenties
Inhoudsopgave
Probleemoplossen
