Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FAULTS
Symptom
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
flashing.
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
'BR' appears in the display
and the operation does not
react.
Fault code F00 / the red lamp
next to the child lock button
is illuminated and the lamp
above the pause button is
flashing.
Fault code F0 ... F6 and FC.
Fault code F7.
Fault code F8 and F08 / the
red lamp next to the child
lock button is illuminated and
the lamp above the pause
button is flashing.
Fault code F9 and/or
continuous
audible signal.
Possible cause
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
The preset time has ended.
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The bridge function is
switched on.
The control panel is dirty or
has water on it.
Defective generator.
The ambient temperature is
not good.
Appliance overheated.
Voltage too high and/or not
connected properly.
Solution
This is normal for certain
pans at a high cooking
setting. This is not harmful for
the pans or hob.
Use a suitable pan (see pages
11 and 12).
Switch the signal off by
pressing on the - or + key of
the timer.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Switch the bridge function off
(see page 15).
Clean the control panel.
Contact the
service department.
Switch off all heat sources
close to the hob.
Allow the appliance to cool
down and
start cooking once again.
Have your connection
changed.
EN 29
Advertenties
Hoofdstukken
Inhoudsopgave
