Advertenties
Beschikbare talen
Beschikbare talen
Caution, important!
After selecting the switching programme "PROG 0" (frost protection, icon "
display "PROG 0" in the display), the comfort or savings temperature cannot be set
(see chapter 11. d).
If you want to set the comfort or savings temperature, first select a different switching
programme than "PROG 0".
• The switching programmes "PROG 10" to "PROG 19" can be freely programmed by you.
Use the button "PROG#" to select, e.g. the switching programme "PROG 10".
The left dash at the 24h timeline flashes; the time "0:00" appears.
Use the buttons "
supposed to keep between 0:00 and 0:59 hours.
The button "
" (3) represents the comfort temperature and the button " " (4) for the savings
temperature (night reduction).
When pushing the button "
button " " (4) will make the dash by the respective hour disappear.
After every push of a button, the flashing dash moves one hour to the right and the hour
displayed is increased by one.
• To set the switching programme for the next weekday, push the button "PROG". At the top
of the display, the wide black bar for the weekday display moves on by one day.
As described above, select the switching programme for the new weekday with the "PROG#"
button (either one of the firmly pre-programmed switching programmes or one of the
switching programmes freely programmed by you).
• To terminate this setting mode, briefly press "OK". The current time appears again in the
upper left of the display.
The setting mode is left automatically if no button is pushed for approx. 10 seconds.
Programming is assumed.
Important!
The switching programme must be programmed for every weekday. The basic
settings have the switching programme "PROG 1" pre-set for every weekday.
" (3) or " " (4) to select the temperature value the thermostat is
" (3), a dash will appear with the respective hour; the
" and
43
Advertenties
