Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
HC302, HC502
6.3
Installing built-in version
Observe the following instructions when installing:
Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the front, fig. 3, page 3).
Key to fig. 3, page 3
No.
Explanation
1
Cold intake air
2
Hot waste air
Leave the device to stand for at least four hours before you connect it
to the power supply so that the refrigerant can flow back into the
compressor.
Make sure that the refrigerator door is able to open at least 100°. Other-
wise the drawers cannot be used.
➤ Mount the refrigerator to the furniture by two screws through the fittings at
the bottom (fig. 4, page 3).
6.4
Connecting the refrigerator to the power supply
A
NOTICE!
UK only: The refrigerator is supplied with a plug fitted with 3 A
fuse. In case this fuse has to be to changed, a 3 A ASTA
approved (BS 1362) fuse must be used.
➤ Connect the plug of the connection cable into the AC mains.
➤ Insert the battery into the thermometer (see chapter "Replacing the
battery of the thermometer" on page 17).
✓ The display turns on.
For the first two seconds the display will not show temperature values; it
shows "--.-". Then the temperature read from the sensor is shown.
EN
Installing and connecting the refrigerator
15
Advertenties
Hoofdstukken
Inhoudsopgave
