Download Inhoudsopgave Inhoud Print deze pagina

External Cleaning; Internal Cleaning; Cleaning The Spray Arms; Troubleshooting - AEG FAVORIT 55600 IM0P Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

34
www.aeg.com

11.2 Cleaning the spray arms

Do not remove the spray arms. If the
holes in the spray arms are clogged,

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with
the help of the information in the table.
Problem and alarm code
You cannot activate the ap-
pliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows
CAUTION!
An incorrect position of the
filters can cause bad
washing results and damage
to the appliance.
.
remove remaining parts of soil with a thin
pointed object.

11.3 External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products,
abrasive cleaning pads or solvents.

11.4 Internal cleaning

• Carefully clean the appliance,
including the rubber gasket of the
door, with a soft moist cloth.
• If you regularly use short duration
programmes, these can leave
deposits of grease and limescale
inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per
month.
With some problems, the display
shows an alarm code.
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no a damage fuse in the fuse
box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance has started the procedure to recharge
the resin inside the water softener. The duration of the
procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Inhoudsopgave