Warning/
Indication on the display unit
Information
Power supply failure warning
(»PF/End«)
Warning
(voltage below 180 V)
Unresponsive display unit and
all buttons
Warning
(voltage over 260 V)
Washing machine standing
by, ready to resume the
washing programme
The time remaining until
programme completion is
alternately lit and off on the
display unit.
Preparation for unlocking the
door
Signal lights will flash on the
display unit.
The appliance cannot be
controlled remotely
The appliance will not
connect to the Wi-Fi network
U:Lo
U:Hi
Error cause and description, what to do?
Upon completion of the washing cycle,
and
will alternate on the display unit. This
informs the user about a power supply failure
and on the effect on the execution of the
washing programme. The washing program
continues where it was interrupted and then
ends successfully.
A prolonged drop of voltage to below 180 V
was detected, which can affect the washing
machine operation.
Check the power supply network to which
your washing machine is connected.
Unplug the power cord from the outlet. Check
if the supply voltage is suitable for the washing
machine (220 240 V); then, plug the power
cord back into the outlet and switch on the
washing machine.
A prolonged voltage surge to over 260 V was
detected, which can affect the washing
machine operation.
Check the power supply network to which
your washing machine is connected.
To resume the washing programme, press the
button (9) START/PAUSE.
Wait for the process to finish. If no errors are
shown after the process, a new cycle can be
run.
Water has to be drained. Wait for the door to
unlock.
Appliance remote control is not activated or
enabled.
Check if the Wi-Fi symbol
is lit, and set the program selector knob (1) to
position REMOTE CONTROL (ConnectLife)
(Remote control) .
The appliance cannot find your Wi-Fi network.
Check whether 2.4 GHz network is activated
on your router and whether the Wi-Fi signal
at the appliance is strong enough.
on the appliance
59