TROUBLE-SHOOTING
What to do ...?
The washing machine shall automatically control the operation of particular functions during the
washing cycle. If any irregularity is identified, this will be indicated by reporting (E:XX) on the display.
The washing machine will report the error until it is switched off. Disturbances from the environment
(e.g. the power grid) may result in various error reports (see TROUBLESHOOTING TABLE).
In such case:
•
Switch off the washing machine and wait for a few seconds.
•
Switch on the washing machine and repeat the washing programme.
•
Most errors during operation can be resolved by the user (see TROUBLESHOOTING TABLE).
•
If the error occurs again, call an authorized service unit.
•
Repairs may only be carried out by an adequately trained person.
The following lists all the errors that the user can see on the user interface.
Troubleshooting and error table
Errors indicated on the display unit may include the following:
Problem/
Indication on the display unit
Error
and problem description
Incorrect settings
Temperature sensor error
Door lock error
Water filling error
What to do?
Restart the program; if the error reoccurs, call
a service technician.
Inlet water too cold. Repeat the washing
program.
If the washing machine reports this error
again, call a service technician.
Make sure the washing machine door is
closed.
If you hear an acoustic signal after pressing
the (9) START/PAUSE button, it means that
the door of the washing machine is not closed.
Close the washing machine door.
Unplug the power cord from the outlet; then,
plug the power cord back into the outlet and
switch on the washing machine.
If the error reoccurs, call a service technician.
Check the following:
•
is the water inlet valve open,
•
is the filter on the water inlet hose clean,
•
is the water supply hose deformed
(clipped, clogged etc.),
•
is the pressure in the water mains
between 0.05 and 0.8 MPa (0.5 8 bar)
55