Inhoudsopgave
Advertenties
6. Before starting the
equipment (Fig. 1 + 2)
m ATTENTION! Only use the welding helmet with the
protection pane (5) and rear pane (12) mounted.
m ATTENTION! Keep the UV filter's sensors (6) clean
and clear.
• Remove the backing foil from the protection pane
(5),the rear pane (12) and helmet casing (1).
• Check the protection pane (5) and rear pane (12) for
scratches, signs of cracks or other damage. If the
protective pane (5) or rear pane (12) has scratches,
cracks or irregularities, it must be replaced before
use, as serious injuries may occur otherwise.
• Convince yourself of the proper functioning of the
automatic welding shield with a bright light source.
Test procedure: Bring the viewing panel closer to an
external light source with a value of more than 40 W
and examine whether or not the screen darkens or
illuminates.
7.
Assembling and operation
7.1. Setting the head circumference (Fig. 3)
• To reduce the size of the rear headband turn the ad-
justable headband button (13) for the rear headband
(9) clockwise.
• To increase the size of the rear headband turn the
adjustable headband button (13) for the rear head-
band (9) counterwise.
7.2. Adjusting the angle and distance (Fig. 4 - 6)
• Loosen the locking buttons for headband (3) on the
left and the right of the automatic welding helmet a
few turns counter wise.
• The angle can be adjusted by locking the tilt angle
adjustment lever (14) on both sides into the corre-
sponding plastic pin (A,B,C,D,E) (The inclination an-
gle adjustment lever must be adjusted in the same
position on both sides). (Fig. 5)
• The distance of the face to the rear pane can be ad-
justed in three settings (F,G,H) (Fig. 6)
• When you have chosen the ideal setting for you,
re-tighten the locking buttons for headband (3) on
both sides.
7.3 Setting of the head height (Fig. 7)
• The head height of the welding helmet can be ad-
justed by moving the plastic pin of the top head band
(8).
m ATTENTION! Adjust the Auto Dimming Welding Hel-
met according to your head size.
7.4 Setting the safety level (Fig. 1 + 8)
• Set the appropriate darkening shade before
the welding procedure (see the following table).
The darkening shade may be manually adjusted
from 9 to 13 by twisting the darkening regulator (2)
on the outside of the helmet.
m ATTENTION! The darkening regulator (2) has the
setting position "grind". If the darkening regulator (9)
is set to this position the automatic darkening is de-
activated. Only use this setting when you do not wish
to use the welding helmet for welding. The automatic
darkening then is no longer active.
www.scheppach.com
GB | 21
Advertenties
Hoofdstukken
Inhoudsopgave
