Inhoudsopgave
Advertenties
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the de-
vice. The operating instructions are intended to help
the user to become familiar with the machine and take
advantage of its application possibilities in accordance
with the recommendations.
The operating instructions contain important infor-
mation on how to operate the machine safely, profes-
sionally and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase relia-
bility and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country. Keep the operating instructions package with
the machine at all times and store it in a plastic cover
to protect it from dirt and moisture.
18 | GB
Read the instruction manual each time before oper-
ating the machine and carefully follow its information.
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
In addition to the safety requirements in these oper-
ating instructions and your country's applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of woodwork-
ing machines.
We cannot accept any liability for damage or accidents
which arise due to a failure to follow these instructions
and the safety instructions.
2. Layout (Fig. 1 + 2)
1.
Helmet casing
2.
Darkening regulator
3.
Locking button for headband (side)
4.
UV/IR Filter
5.
Protection pane
6.
Arc sensor
7.
Solar panel
8.
Headband top
9.
Headband rear
10. Headband front
11. Welding filter
12. Rear pane
13. Adjustable headband botton (back)
14. Tilt angle adjustment lever
3. Scope of delivery
m ATTENTION! The device and packaging materi-
als are not toys! Children must not be allowed to
play with plastic bags, film and small parts! There
is a risk of swallowing and suffocation!
• 1x Auto Dimming Welding Helmet
• 1x Operation manual
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
www.scheppach.com
Advertenties
Hoofdstukken
Inhoudsopgave
