Inhoudsopgave
Advertenties
8.
Slide the device to the left and pull the device downwards.
9.
Place the bracket (Figure 8, pos. 3) on top of
the heater with the short side against the wall.
10. Mark the location of the hole on the wall
(Figure 8, pos. 1).
11. Remove the heater.
12. Drill a 10 mm hole on the marked location
(Figure 8, pos. 1).
13. Insert the plug into the hole (Figure 8, pos. 2).
14. Hang the device in place.
15. Firmly screw the bracket (Figure 8, pos. 3) to
the wall (Figure 8, pos. 4).
Installation
WARNING
Do not insert the power plug into the wall socket before the device is correctly
mounted.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2500 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage matches the voltage indicated on the
identification label of the device. All electrical connections must stay dry under
all circumstances.
1.
Make sure the device is correctly mounted.
2.
Make sure the main switch is in the OFF position (Figure 3, pos. 2).
3.
Insert the power plug into an earthed wall socket that is easily accessible. Use an
earthed wall socket with a minimum power of 2500 Watt.
Remote control
WARNING
Keep out of reach of children.
Swallowing can lead to chemical burns, perforation of soft tissue, and death.
Severe burns can occur within 2 hours of ingestion. Seek medical attention
immediately.
24
Figure 8
Advertenties
Inhoudsopgave
